Momentarily
Displacement Force Thrust
the momentarily displacement
force thrust (to be referred to as MDF thrust) is a closed system
that doesn't use any rocket propulsion nor propels any matter,
molecules or ions..etc to produce thrust. The system facilitated the
theory/phenomenon of the "momentarily displacement force" (not yet proven or put into experiment) resulting
from releasing less dense matter (floats, air bubbles...etc) from
under the surface of a higher density fluid.
A. Momentarily
Displacement Force ( hypothesis )
any matter ingested in fluid
container will cause the fluid level to rise, increasing the pressure
on the container's floor, when that pressure is multiplied to the
floor area, that would be the forces towards the acceleration
(gravity) .
A simple example for that is
a balloon tethered to the floor of a water tank, the downward force
will increase with an amount equal to the balloon size
(displacement), however there's another upward force caused by the
balloon pulling up on the tank floor with a force equal to the
balloon displacement, hence the tank weight doesn't change until the
thread is cut, the upward force is removed and only the extra
downward force remain temporarily for limited time governed by a
group of factors, primarily the balloon reaching the surface or
reaching its terminal velocity.
A.1. Momentarily
Displacement Force Experiment
the experiment illustrated
in the Fig below is a pre-experiment step to picture the momentarily displacement force
a water tank filled with 20
L of water
a 1000 cc block of iron
(density of 8 Gm/cc)
a 1000 cc balloon tethered
to the iron block
weighing scale
phase 1 : before tethering the balloon
water
weight = 20kg
iron
block displacement = 1kg
iron
block force on the tank's floor =7kg
total
scale reading = 28kg
phase
2 : after tethering the balloon
water
weight = 20kg
iron
block displacement = 1kg
balloon
displacement = 1kg
iron
block force on the tank's floor = 6kg
total
scale reading = 28kg
phase
3 : momentarily after releasing the balloon
water
weight = 20kg
iron
block displacement = 1kg
balloon
displacement = 1kg
iron
block force on the tank's floor =7kg
total
scale reading = 29kg
final phase
the balloon reach the
surface or its terminal velocity and the effect is gone, back to
phase 1
B: altering the MDF
expriment
the
experiment is not limited to a tank and scales with setting in Fig
(A) , any tank shape and single scale will give the same result, the
purpose of the above settings is to analyse the forces and prove the
theory without laboratory equipments.
Another
variation could be pumping air at the tank floor with a sufficient
amount of air flow through many pipes or having the whole floor with
suitably distributed holes .
C:
Applying MDF for thrust
it
appears for a moment that the application for the MDF is increasing a
container's weight , since the MDF works along with the gravity
(acceleration) towards earth. But acceleration can be produced in the
desired direction as needed through centrifugal force.
If
water to be rotated in circular tube (doughnut shape) where one side
is equipped with MDF producers , then there will be more force
towards that direction even though the centrifugal acceleration is
equal on both sides


