Thursday, August 10, 2017

Momentarily Displacement Force Thrust

the momentarily displacement force thrust (to be referred to as MDF thrust) is a closed system that doesn't use any rocket propulsion nor propels any matter, molecules or ions..etc to produce thrust. The system facilitated the theory/phenomenon of the "momentarily displacement force" (not yet proven or put into experiment) resulting from releasing less dense matter (floats, air bubbles...etc) from under the surface of a higher density fluid.

A. Momentarily Displacement Force ( hypothesis )

any matter ingested in fluid container will cause the fluid level to rise, increasing the pressure on the container's floor, when that pressure is multiplied to the floor area, that would be the forces towards the acceleration (gravity) .

A simple example for that is a balloon tethered to the floor of a water tank, the downward force will increase with an amount equal to the balloon size (displacement), however there's another upward force caused by the balloon pulling up on the tank floor with a force equal to the balloon displacement, hence the tank weight doesn't change until the thread is cut, the upward force is removed and only the extra downward force remain temporarily for limited time governed by a group of factors, primarily the balloon reaching the surface or reaching its terminal velocity.

A.1. Momentarily Displacement Force Experiment

the experiment illustrated in the Fig below is a pre-experiment step to picture the momentarily displacement force

a water tank filled with 20 L of water
a 1000 cc block of iron (density of 8 Gm/cc)
a 1000 cc balloon tethered to the iron block
weighing scale

phase 1 : before tethering the balloon
water weight = 20kg
iron block displacement = 1kg
iron block force on the tank's floor =7kg
total scale reading = 28kg

phase 2 : after tethering the balloon
water weight = 20kg
iron block displacement = 1kg
balloon displacement = 1kg
iron block force on the tank's floor = 6kg
total scale reading = 28kg

phase 3 : momentarily after releasing the balloon
water weight = 20kg
iron block displacement = 1kg
balloon displacement = 1kg
iron block force on the tank's floor =7kg
total scale reading = 29kg

final phase
the balloon reach the surface or its terminal velocity and the effect is gone, back to phase 1

B: altering the MDF expriment

the experiment is not limited to a tank and scales with setting in Fig (A) , any tank shape and single scale will give the same result, the purpose of the above settings is to analyse the forces and prove the theory without laboratory equipments.

Another variation could be pumping air at the tank floor with a sufficient amount of air flow through many pipes or having the whole floor with suitably distributed holes .



C: Applying MDF for thrust

it appears for a moment that the application for the MDF is increasing a container's weight , since the MDF works along with the gravity (acceleration) towards earth. But acceleration can be produced in the desired direction as needed through centrifugal force.

If water to be rotated in circular tube (doughnut shape) where one side is equipped with MDF producers , then there will be more force towards that direction even though the centrifugal acceleration is equal on both sides




No comments:

Post a Comment